This dinosaur topper was inspired by an illustration sent over to me by one of my lovely customers :) Thank you Sara for letting me share this design with other cake decorators! :)
small rolling pin
mini palette knife tool
small ball tool
piping nozzle - 3 mm
teardrop cutter - 8 mm (or a similar size round cutter)
round cutter - 3 mm
50/50 FP/SP mix* with CMC**:
blue - 340 g(colours: sky blue + violet)
50/50 FP/SP mix:
cream - 12 g
dark blue - 2 g
white - 3 g (amount depends on the depth of the indentation)
red purple - 4 g (rose + violet + dark brown)
ball grey - 5 mm
light blue - 10 mm ball
violet - 5 g
bright green - 8 mm ball (lemon yellow + a touch of sky blue)
* FP = flower paste = gum paste; SP = sugarpaste = fondant; to make the 50/50 mix, mix similar size pieces of both types of paste f.ex. 20 g of FP and 20 g of SP.
**Keep on adding the CMC until the paste gets thick but you can still roll a smooth ball. Add more to the body and head than to the legs or arms.
12.5 cm (without the hat)
16 cm (with the hat)
Cut the ends of the legs off (at an angle; check the angle with the body). Apply some glue on two pieces of cocktail sticks. Insert them in the legs. Make holes in the body (using a dry cocktail stick) where the legs will go. Apply some glue on the legs and attach them.
This page is intended to be viewed online and may not be printed.